5/8″ Rear-Side Cutoff Multi-Tool Holder

The rear side cutoff, multi-tool holder was designed to complement our four-position, gang-tooling tool posts. It can be used in conjunction with the gang-tooling tool post, or on its own for our customers who want to convert their Sherline lathe into a “Chucker Lathe” or gang-tooling lathe.

Our rear side cutoff, multi-tool holder offers a convenient and accurate way to hold up to two, round boring tools with a known center-line-to-center-line distance of 1.500″, and a slot for holding a cutoff tool blade.

For video instructions on “Indicating in Your Gang-Tooling Tool Post,” click on the Video tab above, or visit our Videos page.

Includes the following:

• 5/8″ Rear Side Cutoff Multi-Tool Post Body
• 10-32 x 1″ SHCS (2)
• Extended Tool-Post T-Nut (2)
• 10-32 x 3/4″ SHCS (6)
• #10 Washer (4)
• Steel Dowel Pin 1/4″ x 3/4″ (2)

Using the Part-Off Tool

This holder can be mounted as shown in Figure 1, so the blade is in front of the crosslide. This will allow you to cut off larger diameter parts as long as the section to be parted off does not exceed 1.0” in length (the distance between the back of the part-off blade and the front of the crosslide).

FIGURE 1—The distance from the back of the part-off blade to the front of the crosslide is 1.0″ when the tool holder is perpendicular to the crosslide. Click on the image for a larger view.

Considerations Regarding this Tool Holder and Its Possible End Uses

There are many considerations regarding this tool post and its possible end uses. Please check the instructions for a complete list (click on the Instructions tab above to download the document).